The selection tool should include the following capabilities (similar to ArcGIS):
-set selectable layers/ make only selectable layer
-add to/ replace/ remove from current selection (from Home tab, not just from attribute table)
-clear selected features (from Home tab, not just from attribute table)
-select by attributes/ select by location.
(http://hydrodesktop.codeplex.com/workitem/7370)
Comments: This issue list is no longer active. This issue has been copied to our issue list on github (https://github.com/DotSpatial/DotSpatial/issues) Please check there to find out whether this issue was fixed.
-set selectable layers/ make only selectable layer
-add to/ replace/ remove from current selection (from Home tab, not just from attribute table)
-clear selected features (from Home tab, not just from attribute table)
-select by attributes/ select by location.
(http://hydrodesktop.codeplex.com/workitem/7370)
Comments: This issue list is no longer active. This issue has been copied to our issue list on github (https://github.com/DotSpatial/DotSpatial/issues) Please check there to find out whether this issue was fixed.